P211A — Throttle actuator B: stuck in the open position
| Meaning | The engine computer detects that throttle actuator B stays open or does not close as commanded. More air gets in than needed and the engine may run too fast or unstably. B refers to a second actuator or throttle body, and which one depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Car keeps accelerating or does not slow down when you lift off
Check engine light on
Limited power or limp mode
Poor engine braking
Common causes
Damaged return spring or gears of actuator B
Failed motor of actuator B
Connector or wiring problems
Faulty position sensor B
Faulty engine control unit (rare)
What to do
How to read code P211A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P211A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (1A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P211A mean?
Throttle actuator B: stuck in the open position. The engine computer detects that throttle actuator B stays open or does not close as commanded. More air gets in than needed and the engine may run too fast or unstably. B refers to a second actuator or throttle body, and which one depends on the manufacturer.
Can I keep driving with code P211A active?
With caution: limp mode possible, have it checked soon
Common causes — P211A
Dirty throttle body B or sticking valve Damaged return spring or gears of actuator B Failed motor of actuator B Connector or wiring problems Faulty position sensor B Faulty engine control unit (rare)
How do you fix code P211A?
Have throttle B checked right away: a throttle that does not close can make the car accelerate against the driver's wishes. Avoid driving until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2119 — Throttle body: range or performance fault
- Next code: P211B — Throttle actuator B: stuck in the closed position
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance