P2123 — Throttle/pedal sensor D: signal too high
| Meaning | The engine computer receives from sensor D, on the throttle or the pedal, a voltage higher than normal. This usually points to a wire shorted to supply, a broken ground or a faulty sensor. The letter D is assigned by the manufacturer and many cars do not use it: without your make's diagram I cannot say which sensor it is. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Abnormal or overly sharp pedal response
Rough or high idle
Occasional stalling
Common causes
Wire shorted to supply
Corroded or loose connector
Faulty sensor D
Throttle body or pedal with faulty electronics
Faulty engine control unit (rare)
What to do
How to read code P2123
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P2123 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (23) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2123 mean?
Throttle/pedal sensor D: signal too high. The engine computer receives from sensor D, on the throttle or the pedal, a voltage higher than normal. This usually points to a wire shorted to supply, a broken ground or a faulty sensor. The letter D is assigned by the manufacturer and many cars do not use it: without your make's diagram I cannot say which sensor it is.
Can I keep driving with code P2123 active?
With caution: limp mode possible, have it checked soon
Common causes — P2123
Broken ground of sensor D Wire shorted to supply Corroded or loose connector Faulty sensor D Throttle body or pedal with faulty electronics Faulty engine control unit (rare)
How do you fix code P2123?
Have the ground, connector and wiring of sensor D checked first, then the supply voltage. If power is reduced or idle is too high, avoid using the car in traffic until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2122 — Throttle/pedal sensor D: signal too low
- Next code: P2124 — Pedal/throttle sensor D: intermittent signal
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance