P2124 — Pedal/throttle sensor D: intermittent signal
| Meaning | The engine control unit detected that the signal from one of the accelerator pedal or throttle position sensors, labelled "D" in the standard, drops out or jumps from time to time. The signal is not missing all the time: it comes and goes. Which sensor is "D" depends on the manufacturer and model, so the exact location must be checked on the vehicle's wiring diagram. |
| Family | Powertrain (P) |
Typical symptoms
Jerky or uneven response to the accelerator
Sudden loss of power
Unstable idle speed
Limp mode with reduced power
Engine stalling or hard starting on some occasions
Common causes
Wiring with a partially broken or chafed wire
Worn pedal or throttle sensor
Moisture or water getting into the connector
Sensor supply or ground problem
Internal control unit fault (rare)
What to do
How to read code P2124
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2124 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (24) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2124 mean?
Pedal/throttle sensor D: intermittent signal. The engine control unit detected that the signal from one of the accelerator pedal or throttle position sensors, labelled "D" in the standard, drops out or jumps from time to time. The signal is not missing all the time: it comes and goes. Which sensor is "D" depends on the manufacturer and model, so the exact location must be checked on the vehicle's wiring diagram.
Can I keep driving with code P2124 active?
With caution: limp mode possible, have it checked soon
Common causes — P2124
Loose, corroded or dirty sensor connector terminals Wiring with a partially broken or chafed wire Worn pedal or throttle sensor Moisture or water getting into the connector Sensor supply or ground problem Internal control unit fault (rare)
How do you fix code P2124?
First check the pedal and throttle connectors: they should be fully seated, clean and free of moisture. If you can do it safely, gently move the wiring with the engine running to see whether the fault shows up. If the car suddenly loses power, avoid overtaking and heavy traffic and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2123 — Throttle/pedal sensor D: signal too high
- Next code: P2125 — Pedal/throttle sensor E: circuit fault
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance