P2125 — Pedal/throttle sensor E: circuit fault
| Meaning | The engine control unit found an electrical problem in the circuit of one of the accelerator pedal or throttle position sensors, called "E" in the standard. The signal is not what it expects, so the unit can no longer trust what the pedal or throttle reports. Which sensor is "E" varies by manufacturer, so the vehicle's wiring diagram is needed. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Accelerator that responds poorly or not at all
Uneven idle speed
Engine that will not rev past a certain limit
Common causes
Wire broken, shorted or with damaged insulation
Faulty pedal or throttle sensor
Irregular sensor supply or ground
Internal control unit fault (rare)
What to do
How to read code P2125
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P2125 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (25) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2125 mean?
Pedal/throttle sensor E: circuit fault. The engine control unit found an electrical problem in the circuit of one of the accelerator pedal or throttle position sensors, called "E" in the standard. The signal is not what it expects, so the unit can no longer trust what the pedal or throttle reports. Which sensor is "E" varies by manufacturer, so the vehicle's wiring diagram is needed.
Can I keep driving with code P2125 active?
With caution: limp mode possible, have it checked soon
Common causes — P2125
Damaged or corroded sensor connector Wire broken, shorted or with damaged insulation Faulty pedal or throttle sensor Irregular sensor supply or ground Internal control unit fault (rare)
How do you fix code P2125?
Check the pedal and throttle connector and wiring, looking for damaged wires, dirty terminals or signs of moisture. If the car is in limp mode, drive carefully and only to reach a workshop, since the accelerator response can drop suddenly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2124 — Pedal/throttle sensor D: intermittent signal
- Next code: P2126 — Pedal/throttle sensor E: signal out of range
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance