P212B — Throttle sensor G: signal out of range
| Meaning | The engine control unit detected that the signal from throttle sensor "G" is present but does not match what it expects, for example compared with the other sensors or with the driver's demand. The sensor, the throttle or the wiring is not working as expected. Where sensor "G" sits depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Slow or jerky accelerator response
Reduced power
Uneven idle
Engine stalling when lifting off or at low speed
Common causes
Drifted or worn position sensor
Connections with abnormal resistance
Damaged wiring
Mechanical problem with the throttle or its motor
Control unit fault (rare)
What to do
How to read code P212B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P212B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P212B mean?
Throttle sensor G: signal out of range. The engine control unit detected that the signal from throttle sensor "G" is present but does not match what it expects, for example compared with the other sensors or with the driver's demand. The sensor, the throttle or the wiring is not working as expected. Where sensor "G" sits depends on the manufacturer.
Can I keep driving with code P212B active?
With caution: limp mode possible, have it checked soon
Common causes — P212B
Dirty throttle body with deposits slowing its movement Drifted or worn position sensor Connections with abnormal resistance Damaged wiring Mechanical problem with the throttle or its motor Control unit fault (rare)
How do you fix code P212B?
First check the condition of the throttle body and its connectors: dirt and corroded contacts are among the most common causes. If power is reduced, avoid long trips and have the live sensor values read with a diagnostic tool.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P212A — Throttle sensor G: circuit fault
- Next code: P212C — Throttle sensor G: signal too low
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance