P212C — Throttle sensor G: signal too low
| Meaning | The engine control unit reads a lower voltage than the expected minimum on throttle sensor "G". This usually points to a broken wire, a short to ground, a missing supply voltage or a faulty sensor. Which sensor is "G" depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Limp mode with reduced power
Accelerator responding poorly
Uneven idle
Hard starting in some cases
Common causes
Corroded connector or terminals pushed out of place
Missing reference supply to the sensor
Faulty throttle position sensor
Chafed wiring
Control unit fault (rare)
What to do
How to read code P212C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P212C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P212C mean?
Throttle sensor G: signal too low. The engine control unit reads a lower voltage than the expected minimum on throttle sensor "G". This usually points to a broken wire, a short to ground, a missing supply voltage or a faulty sensor. Which sensor is "G" depends on the manufacturer.
Can I keep driving with code P212C active?
With caution: limp mode possible, have it checked soon
Common causes — P212C
Signal wire shorted to ground or broken Corroded connector or terminals pushed out of place Missing reference supply to the sensor Faulty throttle position sensor Chafed wiring Control unit fault (rare)
How do you fix code P212C?
Check the throttle body connector and wiring, especially where the wires run near brackets or hot parts. In limp mode power may be lacking when overtaking: drive carefully and have the system checked without waiting too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P212B — Throttle sensor G: signal out of range
- Next code: P212D — Throttle sensor G: signal too high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance