Skip to content
Fault code dictionary (DTC)

P212E — Throttle sensor G: intermittent signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine control unit detected that the signal from throttle sensor "G" drops out or changes from time to time, without being permanently faulty. It is often an electrical contact problem. Which sensor is "G" depends on the manufacturer and model.
FamilyPowertrain (P)

Typical symptoms

Check engine light coming on and going off
Sudden, brief loss of power
Jerky accelerator response
Unstable idle
Limp mode appearing now and then

Common causes

Loose connector or corroded terminals
Partially broken wire in the harness
Worn sensor that loses signal at certain positions
Moisture in the connector
Unstable sensor supply or ground
Control unit fault (rare)

What to do

Check that the throttle body connector is fully seated and clean, and look for signs of chafing on the wiring. Intermittent faults are hard to find: note when they happen (cold start, rain, bumps) and tell whoever inspects the car.

How to read code P212E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P212E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P212E mean?

Throttle sensor G: intermittent signal. The engine control unit detected that the signal from throttle sensor "G" drops out or changes from time to time, without being permanently faulty. It is often an electrical contact problem. Which sensor is "G" depends on the manufacturer and model.

Can I keep driving with code P212E active?

With caution: limp mode possible, have it checked soon

Common causes — P212E

Loose connector or corroded terminals Partially broken wire in the harness Worn sensor that loses signal at certain positions Moisture in the connector Unstable sensor supply or ground Control unit fault (rare)

How do you fix code P212E?

Check that the throttle body connector is fully seated and clean, and look for signs of chafing on the wiring. Intermittent faults are hard to find: note when they happen (cold start, rain, bumps) and tell whoever inspects the car.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes