P212D — Throttle sensor G: signal too high
| Meaning | The engine control unit reads a higher voltage than the expected maximum on throttle sensor "G". This usually points to a short to the supply, an open sensor ground or a faulty sensor. Which sensor is "G" varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Inconsistent or hard-to-control accelerator
High or uneven idle
Engine speed not dropping as it should
Common causes
Signal wire shorted to supply
Corroded or damaged connector
Faulty throttle position sensor
Damaged wiring
Control unit fault (rare)
What to do
How to read code P212D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P212D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P212D mean?
Throttle sensor G: signal too high. The engine control unit reads a higher voltage than the expected maximum on throttle sensor "G". This usually points to a short to the supply, an open sensor ground or a faulty sensor. Which sensor is "G" varies by manufacturer.
Can I keep driving with code P212D active?
With caution: limp mode possible, have it checked soon
Common causes — P212D
Open or high-resistance sensor ground Signal wire shorted to supply Corroded or damaged connector Faulty throttle position sensor Damaged wiring Control unit fault (rare)
How do you fix code P212D?
Check the throttle body connectors and wiring, paying attention to ground points and dirty terminals. If engine speed stays high or the accelerator feels inconsistent, have the car checked as soon as possible: it can be dangerous when manoeuvring.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P212C — Throttle sensor G: signal too low
- Next code: P212E — Throttle sensor G: intermittent signal
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance