P2138 — Throttle/Pedal Position Sensor D/E Voltage Correlation
| Meaning | The engine computer noticed a disagreement between the two sensors that track how far you are pressing the accelerator pedal. Because they don't match, the computer doesn't know for sure what you want to do and limits engine power for safety. |
| Family | Powertrain (P) |
Typical symptoms
The check engine light is on
The vehicle may enter a limited power mode often called limp mode
Common causes
Poor electrical connection or corrosion in the pedal wiring harness
Internal failure inside the engine control module
What to do
How to read code P2138
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P2138 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (38) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2138 mean?
Throttle/Pedal Position Sensor D/E Voltage Correlation. The engine computer noticed a disagreement between the two sensors that track how far you are pressing the accelerator pedal. Because they don't match, the computer doesn't know for sure what you want to do and limits engine power for safety.
Can I keep driving with code P2138 active?
With caution: limp mode possible, have it checked soon
Common causes — P2138
Faulty accelerator pedal position sensor assembly Poor electrical connection or corrosion in the pedal wiring harness Internal failure inside the engine control module
How do you fix code P2138?
Have a technician check the wiring plug at the accelerator pedal and test the sensor signals with a diagnostic tool. Since this directly affects vehicle control and responsiveness, you should have it checked promptly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2137 — Throttle/Pedal Position Sensor/Switch "B" / "C" Vo...
- Next code: P2139 — Throttle/Pedal Position Sensor/Switch "D" / "F" Vo...
Related codes
- P2100 — Throttle Actuator Control Motor Circuit/Open
- P2101 — Throttle Actuator Control Motor Circuit Range/Performance
- P2102 — Throttle Actuator Control Motor Circuit Low
- P2103 — Throttle Actuator Control Motor Circuit High
- P2104 — Throttle Actuator Control System - Forced Idle
- P2105 — Throttle Actuator Control System - Forced Engine Shutdown
- P2106 — Throttle Actuator Control System - Forced Limited Power
- P2107 — Throttle Actuator Control Module Processor
- P2108 — Throttle Actuator Control Module Performance
- P2109 — Throttle/Pedal Position Sensor "A" Minimum Stop Performance
- P210A — The cable to component K38/3(Starter lockout relay) has shor...
- P2110 — Throttle Actuator Control System - Forced Limited RPM