P2139 — Pedal/throttle sensors D and F: readings do not agree
| Meaning | The engine control unit compares two position sensors, called "D" and "F" in the standard, which should give values that match each other. Here the two signals disagree, so one of them, or its wiring, is giving a wrong reading. Which sensors are D and F depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Uncertain or jerky accelerator response
Uneven idle
Accelerator seeming dead at some positions
Common causes
Corroded connector or abnormal resistance
Damaged wiring on one of the two circuits
Unstable reference supply or ground
Dirt or a mechanical problem at the pedal or throttle
Control unit fault (rare)
What to do
How to read code P2139
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2139 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (39) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2139 mean?
Pedal/throttle sensors D and F: readings do not agree. The engine control unit compares two position sensors, called "D" and "F" in the standard, which should give values that match each other. Here the two signals disagree, so one of them, or its wiring, is giving a wrong reading. Which sensors are D and F depends on the manufacturer.
Can I keep driving with code P2139 active?
With caution: limp mode possible, have it checked soon
Common causes — P2139
One of the two sensors drifted or worn Corroded connector or abnormal resistance Damaged wiring on one of the two circuits Unstable reference supply or ground Dirt or a mechanical problem at the pedal or throttle Control unit fault (rare)
How do you fix code P2139?
Check the connectors and wiring of the two sensors and make sure the pedal or throttle moves freely. A diagnostic tool is needed to read both values live and see which one is off. With reduced power, drive carefully and do not put it off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2138 — Throttle/Pedal Position Sensor D/E Voltage Correla...
- Next code: P213A — EGR throttle control circuit B: open circuit
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance