P213C — EGR throttle control circuit B: low signal
| Meaning | The control unit has measured a lower voltage than expected in the EGR throttle control circuit (circuit "B"). This usually points to a wire touching ground or a component drawing current abnormally. |
| Family | Powertrain (P) |
Typical symptoms
Irregular idle
Loss of power
Possible limp mode
Exhaust smell or unusual smoke
Common causes
Connector with moisture or corrosion
Internal short circuit in the EGR throttle actuator
Power supply problem on the circuit
Faulty engine control unit (rare)
What to do
How to read code P213C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P213C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (3C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P213C mean?
EGR throttle control circuit B: low signal. The control unit has measured a lower voltage than expected in the EGR throttle control circuit (circuit "B"). This usually points to a wire touching ground or a component drawing current abnormally.
Can I keep driving with code P213C active?
With caution: limp mode possible, have it checked soon
Common causes — P213C
Pinched or chafed wire in the circuit touching ground Connector with moisture or corrosion Internal short circuit in the EGR throttle actuator Power supply problem on the circuit Faulty engine control unit (rare)
How do you fix code P213C?
Inspect the wiring going to the EGR valve, especially where it runs near hot or vibrating parts, and check the connector. Have the circuit checked soon: a short circuit left for a long time can damage the control unit.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P213B — EGR throttle control B: range/performance problem
- Next code: P213D — EGR throttle control circuit B: high signal
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance