P213B — EGR throttle control B: range/performance problem
| Meaning | The control unit commands the EGR throttle valve (circuit "B") but the measured position or behaviour does not match what was requested. The electrical circuit is not necessarily broken: the problem is often mechanical, such as a dirty or sticking valve. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle or engine stalling at low rpm
Loss of power or hesitation when accelerating
Fuel consumption different from usual
More visible exhaust smoke
Common causes
Worn EGR throttle actuator
Leaks or blockages in the recirculation passages
Wiring or connector with abnormal resistance
Unreliable position sensor inside the valve
Faulty engine control unit (rare)
What to do
How to read code P213B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P213B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (3B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P213B mean?
EGR throttle control B: range/performance problem. The control unit commands the EGR throttle valve (circuit "B") but the measured position or behaviour does not match what was requested. The electrical circuit is not necessarily broken: the problem is often mechanical, such as a dirty or sticking valve.
Can I keep driving with code P213B active?
With caution: limp mode possible, have it checked soon
Common causes — P213B
EGR valve or throttle clogged with soot, sticking or slow Worn EGR throttle actuator Leaks or blockages in the recirculation passages Wiring or connector with abnormal resistance Unreliable position sensor inside the valve Faulty engine control unit (rare)
How do you fix code P213B?
First check the condition of the valve and the passages: soot is the most common cause. Also check the wiring and connector. Avoid driving for long in this condition, because the EGR function affects emissions and how the engine runs.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P213A — EGR throttle control circuit B: open circuit
- Next code: P213C — EGR throttle control circuit B: low signal
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance