P213E — Fuel injection system fault: forced engine shutdown
| Meaning | The control unit has detected a fault in the injection system serious enough to stop the engine as a protection. The code is standardised, but the exact cause depends on the manufacturer and the type of system: to know which component is involved you need diagnostic data specific to your car. |
| Family | Powertrain (P) |
Typical symptoms
Difficulty or inability to restart
Check engine light on
Long cranking
Jerky running before the shutdown
Common causes
Problem in the injector electrical circuit
Incorrect fuel pressure
Poor-quality or contaminated fuel
Communication error or control unit fault (rare)
What to do
How to read code P213E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P213E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (3E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P213E mean?
Fuel injection system fault: forced engine shutdown. The control unit has detected a fault in the injection system serious enough to stop the engine as a protection. The code is standardised, but the exact cause depends on the manufacturer and the type of system: to know which component is involved you need diagnostic data specific to your car.
Can I keep driving with code P213E active?
With caution: limp mode possible, have it checked soon
Common causes — P213E
Faulty injectors or abnormal injector supply Problem in the injector electrical circuit Incorrect fuel pressure Poor-quality or contaminated fuel Communication error or control unit fault (rare)
How do you fix code P213E?
Do not keep trying to restart repeatedly and do not drive if the engine cuts out by itself: it is a safety risk. Have it diagnosed with a tool suited to your make before putting the car back on the road.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P213D — EGR throttle control circuit B: high signal
- Next code: P213F — Fuel pump system fault: forced engine shutdown
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance