P213F — Fuel pump system fault: forced engine shutdown
| Meaning | The control unit has detected a fault in the fuel pump system serious enough to stop the engine as a protection. The code is standardised, but the component involved (low- or high-pressure pump, relay, control) depends on the manufacturer and the engine. |
| Family | Powertrain (P) |
Typical symptoms
Hard or impossible restart
Check engine light on
Loss of power before the shutdown
Unusual noise from the pump in the tank
Common causes
Pump relay, fuse or wiring
Clogged fuel filter
Insufficient or uncontrolled fuel pressure
Contaminated fuel
Fault in the pump control unit (rare)
What to do
How to read code P213F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P213F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (3F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P213F mean?
Fuel pump system fault: forced engine shutdown. The control unit has detected a fault in the fuel pump system serious enough to stop the engine as a protection. The code is standardised, but the component involved (low- or high-pressure pump, relay, control) depends on the manufacturer and the engine.
Can I keep driving with code P213F active?
With caution: limp mode possible, have it checked soon
Common causes — P213F
Worn or failed fuel pump Pump relay, fuse or wiring Clogged fuel filter Insufficient or uncontrolled fuel pressure Contaminated fuel Fault in the pump control unit (rare)
How do you fix code P213F?
If the engine cuts out by itself, do not use the car: it is a safety risk. Check the pump fuse and relay and have the fuel pressure verified with the right tool.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P213E — Fuel injection system fault: forced engine shutdow...
- Next code: P2140 — Throttle/pedal sensors E-F: voltage correlation fa...
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance