P2142 — EGR throttle control circuit: high signal
| Meaning | The control unit has measured a higher voltage than expected in the EGR throttle control circuit. This usually points to a short to power, abnormal resistance or a faulty ground. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Reduced performance
Possible limp mode
Dirtier emissions than usual
Common causes
Poor or corroded circuit ground
Faulty EGR throttle actuator
Damaged or corroded connector
Faulty engine control unit (rare)
What to do
How to read code P2142
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2142 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (42) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2142 mean?
EGR throttle control circuit: high signal. The control unit has measured a higher voltage than expected in the EGR throttle control circuit. This usually points to a short to power, abnormal resistance or a faulty ground.
Can I keep driving with code P2142 active?
With caution: limp mode possible, have it checked soon
Common causes — P2142
Wire in contact with a power supply Poor or corroded circuit ground Faulty EGR throttle actuator Damaged or corroded connector Faulty engine control unit (rare)
How do you fix code P2142?
Check the connector, wiring and grounds connected to the EGR valve. If the car goes into limp mode or behaves strangely, have it diagnosed without waiting.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2141 — EGR throttle control circuit: low signal
- Next code: P2143 — EGR vent control circuit: open circuit
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance