P2143 — EGR vent control circuit: open circuit
| Meaning | The control unit has detected that the electrical circuit controlling the EGR vent valve is open, with no continuity. It therefore cannot drive the valve. The precise function of this valve varies between manufacturers, and I have no reliable information that applies to every make. |
| Family | Powertrain (P) |
Typical symptoms
Irregular idle
Loss of performance
Uncertain exhaust gas recirculation operation
Possible limp mode
Common causes
Broken wire or intermittent contact in the circuit
Faulty vent solenoid or actuator
Power or ground problem
Faulty engine control unit (rare)
What to do
How to read code P2143
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2143 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (43) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2143 mean?
EGR vent control circuit: open circuit. The control unit has detected that the electrical circuit controlling the EGR vent valve is open, with no continuity. It therefore cannot drive the valve. The precise function of this valve varies between manufacturers, and I have no reliable information that applies to every make.
Can I keep driving with code P2143 active?
With caution: limp mode possible, have it checked soon
Common causes — P2143
Loose, corroded or damaged connector Broken wire or intermittent contact in the circuit Faulty vent solenoid or actuator Power or ground problem Faulty engine control unit (rare)
How do you fix code P2143?
First check the valve connector and wiring, looking for pulled, burnt or corroded wires. It is not normally an immediate emergency, but it is best to have it diagnosed soon so the fault does not get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2142 — EGR throttle control circuit: high signal
- Next code: P2144 — EGR vent control circuit: low signal
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance