P2150 — Fuel injector group B: supply voltage too low
| Meaning | The engine control unit measured too low a voltage on the circuit that powers a group of injectors, labelled group B. Which injectors belong to that group depends on the manufacturer and engine, so the wiring diagram for your car is needed. With low voltage the injectors may not open properly. |
| Family | Powertrain (P) |
Typical symptoms
Rough or jerky running
Hard starting
Lack of power
Possible limp mode
Common causes
Oxidised or loose connectors
Problem with the injector supply fuse or relay
Weak battery or ground connection
Faulty driver inside the engine control unit
What to do
How to read code P2150
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2150 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (50) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2150 mean?
Fuel injector group B: supply voltage too low. The engine control unit measured too low a voltage on the circuit that powers a group of injectors, labelled group B. Which injectors belong to that group depends on the manufacturer and engine, so the wiring diagram for your car is needed. With low voltage the injectors may not open properly.
Can I keep driving with code P2150 active?
With caution: limp mode possible, have it checked soon
Common causes — P2150
Injector supply wiring with high resistance or a poor contact Oxidised or loose connectors Problem with the injector supply fuse or relay Weak battery or ground connection Faulty driver inside the engine control unit
How do you fix code P2150?
Start with the battery, grounds, fuses and relay of the injector supply, then check the connectors. If the engine runs roughly or loses power, avoid long trips until it is fixed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P214F — Reductant (AdBlue) heater A: current too high
- Next code: P2151 — Fuel injector group B: supply voltage too high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance