P2151 — Fuel injector group B: supply voltage too high
| Meaning | The engine control unit detected too high a voltage on the supply circuit of injector group B. Which injectors are in group B is set by the manufacturer. It can come from an abnormal supply or a fault in the control unit's internal driver. |
| Family | Powertrain (P) |
Typical symptoms
Irregular engine running
Possible stalling or hard starting
Fuel use that seems abnormal
Possible limp mode
Common causes
Wiring shorted to a higher supply
Injector supply relay stuck or faulty
Damaged connectors
Faulty engine control unit
What to do
How to read code P2151
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2151 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (51) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2151 mean?
Fuel injector group B: supply voltage too high. The engine control unit detected too high a voltage on the supply circuit of injector group B. Which injectors are in group B is set by the manufacturer. It can come from an abnormal supply or a fault in the control unit's internal driver.
Can I keep driving with code P2151 active?
With caution: limp mode possible, have it checked soon
Common causes — P2151
Charging system giving excessive voltage (alternator or regulator) Wiring shorted to a higher supply Injector supply relay stuck or faulty Damaged connectors Faulty engine control unit
How do you fix code P2151?
Check the charging voltage with the engine running and the condition of the relay and wiring for the injector supply. Excess voltage can damage other components, so don't put it off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2150 — Fuel injector group B: supply voltage too low
- Next code: P2152 — Fuel injector group C: supply circuit open
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance