P218D — Throttle/fuel inhibit circuit B signal low
| Meaning | The control unit measured a lower voltage than expected in throttle/fuel inhibit circuit B. This usually means a broken wire, a short to ground, or a component that no longer powers the circuit. Which part is involved depends on the manufacturer and I have no reliable details for your make. |
| Family | Powertrain (P) |
Typical symptoms
Low power or limp mode
Unresponsive throttle
Hard starting or stalling
Irregular engine speed
Common causes
Disconnected, wet or corroded connector
Missing supply to the circuit (fuse or relay, where fitted)
A connected component has failed
Faulty control unit (rare)
What to do
How to read code P218D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P218D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (8D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P218D mean?
Throttle/fuel inhibit circuit B signal low. The control unit measured a lower voltage than expected in throttle/fuel inhibit circuit B. This usually means a broken wire, a short to ground, or a component that no longer powers the circuit. Which part is involved depends on the manufacturer and I have no reliable details for your make.
Can I keep driving with code P218D active?
With caution: limp mode possible, have it checked soon
Common causes — P218D
Broken wire or short to ground Disconnected, wet or corroded connector Missing supply to the circuit (fuse or relay, where fitted) A connected component has failed Faulty control unit (rare)
How do you fix code P218D?
First check fuses, connectors and the condition of the wiring in the affected area, then have the circuit voltage measured with a tester. If the engine stalls or loses power, don't keep using the car normally.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P218C — Throttle/fuel inhibit circuit B performance fault
- Next code: P218E — Throttle/fuel inhibit circuit B signal high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance