P218E — Throttle/fuel inhibit circuit B signal high
| Meaning | The control unit measured a higher voltage than expected in throttle/fuel inhibit circuit B. This usually points to a wire shorted to supply voltage, an open circuit, or a component forcing the signal. The precise meaning depends on the manufacturer and I have no reliable details for your make. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Abnormal throttle response
Sudden stalling
Irregular idle
Common causes
Open circuit from a broken wire or connector
A connected component forcing the signal
Wiring damaged by heat or rubbing
Faulty control unit (rare)
What to do
How to read code P218E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P218E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (8E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P218E mean?
Throttle/fuel inhibit circuit B signal high. The control unit measured a higher voltage than expected in throttle/fuel inhibit circuit B. This usually points to a wire shorted to supply voltage, an open circuit, or a component forcing the signal. The precise meaning depends on the manufacturer and I have no reliable details for your make.
Can I keep driving with code P218E active?
With caution: limp mode possible, have it checked soon
Common causes — P218E
Wire shorted to supply voltage Open circuit from a broken wire or connector A connected component forcing the signal Wiring damaged by heat or rubbing Faulty control unit (rare)
How do you fix code P218E?
Inspect the wiring and connectors, especially where wires run near hot or moving parts. An electrical test will show which part of the circuit is faulty; if the engine loses power, limit use of the car.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P218D — Throttle/fuel inhibit circuit B signal low
- Next code: P218F — Reductant no flow detected (AdBlue)
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance