P2193 — System too lean at higher load, bank 2
| Meaning | The control unit has found that the mixture on bank 2, the side without cylinder 1, is too lean when the engine is under load: too little fuel for the amount of air. Under strain the engine can lose power and run hotter. |
| Family | Powertrain (P) |
Typical symptoms
Lack of power when accelerating or climbing
Jerks or flat spots under load
Rough idle
Possible popping
Harder starting
Common causes
Low fuel pressure (weak pump or clogged filter)
Dirty or partly blocked injectors
Dirty air flow meter
Exhaust leak ahead of the oxygen sensor
Faulty bank 2 oxygen sensor
What to do
How to read code P2193
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2193 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (93) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2193 mean?
System too lean at higher load, bank 2. The control unit has found that the mixture on bank 2, the side without cylinder 1, is too lean when the engine is under load: too little fuel for the amount of air. Under strain the engine can lose power and run hotter.
Can I keep driving with code P2193 active?
With caution: limp mode possible, have it checked soon
Common causes — P2193
Air leak after the air flow meter on the bank 2 side Low fuel pressure (weak pump or clogged filter) Dirty or partly blocked injectors Dirty air flow meter Exhaust leak ahead of the oxygen sensor Faulty bank 2 oxygen sensor
How do you fix code P2193?
Check air leaks and the intake manifold hoses first, then the fuel pressure. Avoid demanding trips or heavy loads until it's fixed, as a lean mixture heats the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2192 — System too rich at higher load, bank 1
- Next code: P2194 — System too rich at higher load, bank 2
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance