P21A5 — Cylinder 10 air-fuel mixture imbalance
| Meaning | The engine computer found that the air-fuel mixture in cylinder 10 differs abnormally from the other cylinders. An engine with at least ten cylinders is normally a V10 or V12. Cylinder 10 is running too rich or too lean, and the code only shows where to look. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle or engine shaking
Loss of power when accelerating
Higher fuel consumption than usual
Smell of unburned fuel from the exhaust
Jerking while driving
Common causes
Air leak or bad gasket near cylinder 10
Worn spark plug or ignition coil on cylinder 10
Low compression in cylinder 10 (valve or piston rings)
Oxygen sensor on the affected bank reading incorrectly
Damaged wiring or connector at the injector
What to do
How to read code P21A5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21A5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (A5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21A5 mean?
Cylinder 10 air-fuel mixture imbalance. The engine computer found that the air-fuel mixture in cylinder 10 differs abnormally from the other cylinders. An engine with at least ten cylinders is normally a V10 or V12. Cylinder 10 is running too rich or too lean, and the code only shows where to look.
Can I keep driving with code P21A5 active?
With caution: limp mode possible, have it checked soon
Common causes — P21A5
Cylinder 10 injector dirty, leaking or delivering too little Air leak or bad gasket near cylinder 10 Worn spark plug or ignition coil on cylinder 10 Low compression in cylinder 10 (valve or piston rings) Oxygen sensor on the affected bank reading incorrectly Damaged wiring or connector at the injector
How do you fix code P21A5?
First check whether misfire or fuel trim codes are also stored, and which bank cylinder 10 belongs to. Then inspect the spark plug, coil and injector of that cylinder and look for air leaks. Driving for long like this is not recommended, because the catalytic converter can be ruined.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21A4 — Cylinder 9 air-fuel mixture imbalance
- Next code: P21A6 — Cylinder 11 air-fuel mixture imbalance
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance