P21C6 — Reductant level sensor B stuck
| Meaning | The control unit detected that reductant (AdBlue) level sensor B is not changing its value as it should: it seems stuck on one reading. It can be the sensor itself or the tank. Which one is sensor B depends on the manufacturer, so I can't say for sure where it is on your car. |
| Family | Powertrain (P) |
Typical symptoms
AdBlue level gauge always stuck
Low-level messages even with a full tank
Level shown as fine even when the tank is nearly empty
Power limitation on some vehicles
Common causes
Faulty sensor
Damaged wiring or connector
Frozen or contaminated fluid
Faulty tank module
What to do
How to read code P21C6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21C6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (C6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21C6 mean?
Reductant level sensor B stuck. The control unit detected that reductant (AdBlue) level sensor B is not changing its value as it should: it seems stuck on one reading. It can be the sensor itself or the tank. Which one is sensor B depends on the manufacturer, so I can't say for sure where it is on your car.
Can I keep driving with code P21C6 active?
With caution: limp mode possible, have it checked soon
Common causes — P21C6
Level sensor dirty or covered in urea crystals Faulty sensor Damaged wiring or connector Frozen or contaminated fluid Faulty tank module
How do you fix code P21C6?
Have the sensor and tank checked, also confirming the fluid is the right one and not contaminated. Until then, don't trust the gauge: check the level by eye so you don't run out of AdBlue.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21C5 — Reductant level sensor A stuck
- Next code: P21C7 — Reductant control module power relay circuit open
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance