P21C7 — Reductant control module power relay circuit open
| Meaning | The control unit detected an open circuit in the control of the relay, or relays, that power the reductant (AdBlue) control module. Without power the system cannot dose the fluid into the exhaust. How exactly it is detected depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Message about an emissions system fault
AdBlue system not dosing
Power limitation on some vehicles
Restart lockout after a certain distance on some vehicles
Common causes
Faulty relay
Broken wire or corroded connector
Missing power or ground at the module
Faulty AdBlue control module
What to do
How to read code P21C7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21C7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (C7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21C7 mean?
Reductant control module power relay circuit open. The control unit detected an open circuit in the control of the relay, or relays, that power the reductant (AdBlue) control module. Without power the system cannot dose the fluid into the exhaust. How exactly it is detected depends on the manufacturer.
Can I keep driving with code P21C7 active?
With caution: limp mode possible, have it checked soon
Common causes — P21C7
Blown relay fuse Faulty relay Broken wire or corroded connector Missing power or ground at the module Faulty AdBlue control module
How do you fix code P21C7?
Have the fuses, relays and connectors checked first, and confirm the module is receiving power. Don't wait too long: with the AdBlue system out of action emissions rise and many vehicles restrict restarting.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21C6 — Reductant level sensor B stuck
- Next code: P21C8 — AdBlue module power relay: control circuit low
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance