P21C8 — AdBlue module power relay: control circuit low
| Meaning | The control unit detected that the voltage on the circuit that drives the power relay of the reductant (AdBlue) control module is lower than expected. This can be a short to ground or a broken wire. The module may not get power, and the SCR system may not work properly. |
| Family | Powertrain (P) |
Typical symptoms
Warning light or message about AdBlue or emissions
Warning of reduced power or of a no-restart condition after a set distance
AdBlue system not dosing
Higher nitrogen oxide emissions than normal
Common causes
Pinched or chafed wiring touching ground
Faulty relay
Blown fuse or a power supply problem to the module
Faulty AdBlue control module
What to do
How to read code P21C8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21C8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (C8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21C8 mean?
AdBlue module power relay: control circuit low. The control unit detected that the voltage on the circuit that drives the power relay of the reductant (AdBlue) control module is lower than expected. This can be a short to ground or a broken wire. The module may not get power, and the SCR system may not work properly.
Can I keep driving with code P21C8 active?
With caution: limp mode possible, have it checked soon
Common causes — P21C8
Corroded or loose connector at the relay or module Pinched or chafed wiring touching ground Faulty relay Blown fuse or a power supply problem to the module Faulty AdBlue control module
How do you fix code P21C8?
First check the fuses, relay and connectors of the AdBlue module, looking for water, corrosion or damaged wires. Don't ignore it for long: many cars limit power or block restart when the SCR system isn't working. Have the electrical circuit tested with a diagnostic tool as soon as you can.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21C7 — Reductant control module power relay circuit open
- Next code: P21C9 — AdBlue module power relay: control circuit high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance