P21DB — Cylinder 1 injector B: circuit low
| Meaning | The control unit detected too low a voltage in the circuit of the second injector (injector B) of cylinder 1. This usually points to a wire shorted to ground or an injector with an internal fault. What injector B means depends on the manufacturer: it often refers to a second injector per cylinder. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Misfires (jerking)
Hard starting
The engine may run on one cylinder less
Common causes
Injector with a shorted winding
Connector with water or corrosion
Injector driver problem in the control unit
Wiring damaged after work on the engine
What to do
How to read code P21DB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21DB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (DB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21DB mean?
Cylinder 1 injector B: circuit low. The control unit detected too low a voltage in the circuit of the second injector (injector B) of cylinder 1. This usually points to a wire shorted to ground or an injector with an internal fault. What injector B means depends on the manufacturer: it often refers to a second injector per cylinder.
Can I keep driving with code P21DB active?
With caution: limp mode possible, have it checked soon
Common causes — P21DB
Injector wire shorted to ground by chafing Injector with a shorted winding Connector with water or corrosion Injector driver problem in the control unit Wiring damaged after work on the engine
How do you fix code P21DB?
First check the wiring and connector of the cylinder 1 injector B, looking for spots where the wire could touch metal. Then the injector's resistance is measured. Avoid driving for long with misfires, because the catalytic converter can overheat.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21DA — Cylinder 12 injector B: open or faulty circuit
- Next code: P21DC — Cylinder 1 injector B circuit: signal too high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance