P222A — Barometric pressure sensor B circuit fault
| Meaning | The control unit detected an electrical fault in the circuit of the second barometric pressure sensor, labelled "B". It measures outside air pressure, used to adjust fuel and boost for altitude and weather. Exactly which sensor is B depends on the manufacturer, and I can't say without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Engine less lively, especially in the mountains
Non-ideal mixture or smoke
Irregular turbo behavior
Uncertain starting in some conditions
Common causes
Damaged or broken wiring
Faulty barometric sensor B
Insufficient power supply or ground to the sensor
Faulty engine control unit
What to do
How to read code P222A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P222A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (2A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P222A mean?
Barometric pressure sensor B circuit fault. The control unit detected an electrical fault in the circuit of the second barometric pressure sensor, labelled "B". It measures outside air pressure, used to adjust fuel and boost for altitude and weather. Exactly which sensor is B depends on the manufacturer, and I can't say without knowing the make.
Can I keep driving with code P222A active?
With caution: limp mode possible, have it checked soon
Common causes — P222A
Corroded or loose sensor connector Damaged or broken wiring Faulty barometric sensor B Insufficient power supply or ground to the sensor Faulty engine control unit
How do you fix code P222A?
First check the sensor connector and wiring, then verify power and ground. Since the location of sensor B varies from model to model, the vehicle's wiring diagram needs to be consulted. You can drive with care, but it is best to have the fault checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2229 — Barometric pressure sensor circuit high
- Next code: P222B — Barometric pressure sensor B reading implausible
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3