P222D — Barometric pressure sensor B: signal too high
| Meaning | The control unit detected a voltage above the expected maximum on the second atmospheric pressure sensor (the "B" one). The reading is not believable, so the computer cannot trust its altitude correction. The location of sensor B varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Rough idle
Fuel use that seems higher
Throttle response that feels less smooth
Common causes
Open or high-resistance sensor ground
Faulty barometric pressure sensor
Damaged or moist connector
Internal control unit fault (uncommon)
What to do
How to read code P222D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P222D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (2D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P222D mean?
Barometric pressure sensor B: signal too high. The control unit detected a voltage above the expected maximum on the second atmospheric pressure sensor (the "B" one). The reading is not believable, so the computer cannot trust its altitude correction. The location of sensor B varies by manufacturer.
Can I keep driving with code P222D active?
With caution: limp mode possible, have it checked soon
Common causes — P222D
Signal wire shorted to the supply voltage Open or high-resistance sensor ground Faulty barometric pressure sensor Damaged or moist connector Internal control unit fault (uncommon)
How do you fix code P222D?
Check the sensor wiring and connector, especially the ground wire and the signal wire. It is not an emergency, but it is worth reading live data to compare the two pressure sensors.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P222C — Barometric pressure sensor B: signal too low
- Next code: P222E — Barometric pressure sensor B: erratic signal
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3