P222C — Barometric pressure sensor B: signal too low
| Meaning | The control unit read a voltage below the expected minimum on the second atmospheric pressure sensor (the "B" one). This sensor helps the engine computer correct air and fuel for altitude and weather. Where sensor B is located depends on the manufacturer: on some vehicles it sits in the intake duct, on others it is built into the control unit. |
| Family | Powertrain (P) |
Typical symptoms
Less power than usual, especially uphill
Rough or unstable idle
Slightly hesitant starting when the engine is warm
Black smoke or a rich-mixture smell in some cases
Common causes
Broken sensor wire or a wire shorted to ground
Faulty barometric pressure sensor
Missing or too-low 5 volt supply to the sensor
Internal control unit fault (uncommon)
What to do
How to read code P222C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P222C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (2C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P222C mean?
Barometric pressure sensor B: signal too low. The control unit read a voltage below the expected minimum on the second atmospheric pressure sensor (the "B" one). This sensor helps the engine computer correct air and fuel for altitude and weather. Where sensor B is located depends on the manufacturer: on some vehicles it sits in the intake duct, on others it is built into the control unit.
Can I keep driving with code P222C active?
With caution: limp mode possible, have it checked soon
Common causes — P222C
Corroded or poorly seated sensor connector Broken sensor wire or a wire shorted to ground Faulty barometric pressure sensor Missing or too-low 5 volt supply to the sensor Internal control unit fault (uncommon)
How do you fix code P222C?
Start by checking the sensor connector and wiring for corrosion, water or chafed wires. You can drive carefully for a short time, but do not put it off too long: the control unit is running on substitute values and driveability can get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P222B — Barometric pressure sensor B reading implausible
- Next code: P222D — Barometric pressure sensor B: signal too high
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3