P2240 — O2 sensor bank 2 sensor 1: positive current control circuit open
| Meaning | The engine computer found that the positive current control circuit of the upstream oxygen sensor on bank 2 is broken or not responding. This wide-band sensor is used to measure the air-fuel mixture accurately. Without a valid signal, the computer cannot correct the mixture properly on that bank. |
| Family | Powertrain (P) |
Typical symptoms
Rough or unstable idle
Higher fuel consumption than usual
Loss of power or sluggish throttle response
Smell of unburned fuel from the exhaust
Common causes
Broken or cut sensor wire, for example from rubbing against the exhaust
Faulty wide-band oxygen sensor
Incorrect ground or supply to the sensor
Rarely, an internal fault in the engine computer
What to do
How to read code P2240
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2240 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (40) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2240 mean?
O2 sensor bank 2 sensor 1: positive current control circuit open. The engine computer found that the positive current control circuit of the upstream oxygen sensor on bank 2 is broken or not responding. This wide-band sensor is used to measure the air-fuel mixture accurately. Without a valid signal, the computer cannot correct the mixture properly on that bank.
Can I keep driving with code P2240 active?
With caution: limp mode possible, have it checked soon
Common causes — P2240
Corroded, loose or damaged connector on the bank 2 upstream oxygen sensor Broken or cut sensor wire, for example from rubbing against the exhaust Faulty wide-band oxygen sensor Incorrect ground or supply to the sensor Rarely, an internal fault in the engine computer
How do you fix code P2240?
First check the connector and wiring of the bank 2 upstream sensor, looking for pinched, burnt or corroded wires. If the wiring is fine, the sensor itself needs to be tested with a suitable tool. You can drive for a short time, but don't put it off for long because the mixture is not being regulated properly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P223F — O2 sensor bank 2: reference resistance out of rang...
- Next code: P2241 — O2 sensor bank 2 sensor 1: positive current contro...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3