P2241 — O2 sensor bank 2 sensor 1: positive current control circuit low
| Meaning | The engine computer measured too low a signal in the positive current control circuit of the upstream oxygen sensor on bank 2. This usually means that circuit is shorted to ground or that the sensor is not working as it should. Mixture control on that bank suffers as a result. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Engine that occasionally jerks or hesitates under acceleration
Increased fuel consumption
Smoke or unusual smell from the exhaust
Common causes
Damaged connector or moisture inside it
Faulty wide-band oxygen sensor
Wiring pinched or burnt near the exhaust
Rarely, a fault in the engine computer's internal circuit
What to do
How to read code P2241
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2241 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (41) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2241 mean?
O2 sensor bank 2 sensor 1: positive current control circuit low. The engine computer measured too low a signal in the positive current control circuit of the upstream oxygen sensor on bank 2. This usually means that circuit is shorted to ground or that the sensor is not working as it should. Mixture control on that bank suffers as a result.
Can I keep driving with code P2241 active?
With caution: limp mode possible, have it checked soon
Common causes — P2241
Sensor wire with damaged insulation touching ground Damaged connector or moisture inside it Faulty wide-band oxygen sensor Wiring pinched or burnt near the exhaust Rarely, a fault in the engine computer's internal circuit
How do you fix code P2241?
Inspect the wiring and connector of the bank 2 upstream sensor, especially where it runs near the exhaust or where wires can rub. If you find no visible damage, an electrical measurement on the circuit is needed. Have the car checked within a reasonable time so the engine doesn't keep running on a badly regulated mixture.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2240 — O2 sensor bank 2 sensor 1: positive current contro...
- Next code: P2242 — O2 sensor bank 2 sensor 1: positive current contro...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3