P2242 — O2 sensor bank 2 sensor 1: positive current control circuit high
| Meaning | The engine computer detected too high a signal in the positive current control circuit of the upstream oxygen sensor on bank 2. It can come from a short to a power supply wire or from a faulty sensor. As a result, the computer cannot read the mixture on that bank reliably. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of performance
Higher fuel consumption
In some cases the engine stalls or is slow to restart
Common causes
Damaged or corroded connector, or bent pins
Faulty wide-band oxygen sensor
Wiring damaged by heat or rubbing
Rarely, an internal fault in the engine computer
What to do
How to read code P2242
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2242 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (42) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2242 mean?
O2 sensor bank 2 sensor 1: positive current control circuit high. The engine computer detected too high a signal in the positive current control circuit of the upstream oxygen sensor on bank 2. It can come from a short to a power supply wire or from a faulty sensor. As a result, the computer cannot read the mixture on that bank reliably.
Can I keep driving with code P2242 active?
With caution: limp mode possible, have it checked soon
Common causes — P2242
Sensor wire touching a power supply wire Damaged or corroded connector, or bent pins Faulty wide-band oxygen sensor Wiring damaged by heat or rubbing Rarely, an internal fault in the engine computer
How do you fix code P2242?
First check the connector and the wiring run of the bank 2 upstream sensor, looking for bare wires or wires touching other cables. If the wiring is fine, suspicion moves to the sensor. Don't leave it too long, because the mixture is being corrected using unreliable data.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2241 — O2 sensor bank 2 sensor 1: positive current contro...
- Next code: P2243 — O2 sensor bank 1 sensor 1: reference voltage circu...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3