Skip to content
Fault code dictionary (DTC)

P2249 — O2 sensor bank 2 sensor 1: reference voltage circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer measured too low a reference voltage in the circuit of the upstream oxygen sensor on bank 2. This normally indicates a short to ground in the wiring or a faulty sensor. The mixture reading on that bank becomes unreliable.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Unstable idle
Jerking or hesitation when accelerating
Increased fuel consumption
Reduced performance

Common causes

Sensor wire with worn insulation touching ground
Wet, corroded or damaged connector
Faulty wide-band oxygen sensor
Wiring pinched or burnt near the exhaust
Rarely, an internal fault in the engine computer

What to do

First look at the wiring of the bank 2 upstream sensor near the exhaust and at the connector, looking for burnt insulation or pinched wires. If you find nothing, electrical measurements are needed. Better not to delay for long, because the mixture is not being regulated correctly.

How to read code P2249

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2249 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (49) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2249 mean?

O2 sensor bank 2 sensor 1: reference voltage circuit low. The engine computer measured too low a reference voltage in the circuit of the upstream oxygen sensor on bank 2. This normally indicates a short to ground in the wiring or a faulty sensor. The mixture reading on that bank becomes unreliable.

Can I keep driving with code P2249 active?

With caution: limp mode possible, have it checked soon

Common causes — P2249

Sensor wire with worn insulation touching ground Wet, corroded or damaged connector Faulty wide-band oxygen sensor Wiring pinched or burnt near the exhaust Rarely, an internal fault in the engine computer

How do you fix code P2249?

First look at the wiring of the bank 2 upstream sensor near the exhaust and at the connector, looking for burnt insulation or pinched wires. If you find nothing, electrical measurements are needed. Better not to delay for long, because the mixture is not being regulated correctly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes