P2257 — Secondary air injection: control circuit A low
| Meaning | The engine computer controls the system that blows fresh air into the exhaust on a cold engine, so unburnt hydrocarbons burn off sooner. In control circuit A it detected a voltage that is too low. Which part is wired to circuit A, such as the pump or a relay, depends on the make and model. |
| Family | Powertrain (P) |
Typical symptoms
Different or missing pump noise at cold start
Higher emissions just after starting
Possible emissions test failure
Usually no difference in driving
Common causes
Wiring shorted to ground
Corroded or wet connector
Secondary air pump or valve with shorted coil
Blown fuse
Faulty engine computer (rare)
What to do
How to read code P2257
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2257 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (57) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2257 mean?
Secondary air injection: control circuit A low. The engine computer controls the system that blows fresh air into the exhaust on a cold engine, so unburnt hydrocarbons burn off sooner. In control circuit A it detected a voltage that is too low. Which part is wired to circuit A, such as the pump or a relay, depends on the make and model.
Can I keep driving with code P2257 active?
With caution: limp mode possible, have it checked soon
Common causes — P2257
Faulty secondary air pump relay Wiring shorted to ground Corroded or wet connector Secondary air pump or valve with shorted coil Blown fuse Faulty engine computer (rare)
How do you fix code P2257?
First check the fuse and relay of the secondary air system, then the wiring and connectors of the pump. The car can usually be driven normally, but don't leave it too long since the system keeps emissions clean.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2256 — Bank 2 sensor 1 O2 sensor: pumping current circuit...
- Next code: P2258 — Secondary air injection: control circuit A high
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3