Skip to content
Fault code dictionary (DTC)

P2258 — Secondary air injection: control circuit A high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer controls the system that blows fresh air into the exhaust on a cold engine. In control circuit A it detected a voltage that is too high, meaning the control is not behaving as it should. Which part is on circuit A depends on the make and model.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Air pump running constantly or not stopping
Higher emissions after a cold start
Possible emissions test problem
Usually no obvious change in driving

Common causes

Stuck or faulty secondary air pump relay
Control wire touching a power supply
Corroded or damaged connector
Secondary air pump or valve with an electrical fault
Faulty engine computer (rare)

What to do

Check the relay, wiring and connectors of the secondary air system. If you hear the pump running for a long time or not stopping, switch off the engine and have the car checked, since the pump can overheat.

How to read code P2258

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2258 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (58) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2258 mean?

Secondary air injection: control circuit A high. The engine computer controls the system that blows fresh air into the exhaust on a cold engine. In control circuit A it detected a voltage that is too high, meaning the control is not behaving as it should. Which part is on circuit A depends on the make and model.

Can I keep driving with code P2258 active?

With caution: limp mode possible, have it checked soon

Common causes — P2258

Stuck or faulty secondary air pump relay Control wire touching a power supply Corroded or damaged connector Secondary air pump or valve with an electrical fault Faulty engine computer (rare)

How do you fix code P2258?

Check the relay, wiring and connectors of the secondary air system. If you hear the pump running for a long time or not stopping, switch off the engine and have the car checked, since the pump can overheat.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes