P226E — Particulate filter deteriorated or empty, bank 2
| Meaning | The control unit has found that the bank 2 particulate filter does not behave like an intact filter. It may be damaged, hollowed out inside or missing. This applies to engines with two exhaust banks, such as V6 or V8. |
| Family | Powertrain (P) |
Typical symptoms
Unusual smoke or smell from the exhaust
Exhaust sound different from usual
Loss of power
More frequent or failed regenerations
Common causes
Filter removed or replaced with an unsuitable one
Faulty differential pressure sensors or blocked sensor lines
Damage from overheating during regenerations
Exhaust leaks near the filter
What to do
How to read code P226E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P226E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (6E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P226E mean?
Particulate filter deteriorated or empty, bank 2. The control unit has found that the bank 2 particulate filter does not behave like an intact filter. It may be damaged, hollowed out inside or missing. This applies to engines with two exhaust banks, such as V6 or V8.
Can I keep driving with code P226E active?
With caution: limp mode possible, have it checked soon
Common causes — P226E
Broken or melted ceramic core inside the filter Filter removed or replaced with an unsuitable one Faulty differential pressure sensors or blocked sensor lines Damage from overheating during regenerations Exhaust leaks near the filter
How do you fix code P226E?
Have the differential pressure sensors, their lines and the condition of the bank 2 filter checked. If the filter is damaged it has to be repaired or replaced as the manufacturer requires. With the light on, avoid long trips and heavy loads.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P226D — Particulate filter deteriorated or empty, bank 1
- Next code: P226F — Turbo boost control B: slow response
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3