P227A — Barometric pressure sensor C circuit fault
| Meaning | The control unit has found an electrical problem in the circuit of barometric pressure sensor 'C'. The sensor measures outside air pressure, which is used to adjust fuelling and boost for altitude. Which sensor is 'C' depends on the manufacturer: I have no reliable detail for any particular make. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power, especially uphill or at altitude
Possible reduced-power mode
Smoke from the exhaust on diesels
Irregular idle or revs in some cases
Common causes
Broken or shorted wiring
Faulty sensor
Fault in the sensor's supply or ground
Internal fault in the control unit, rare
What to do
How to read code P227A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P227A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (7A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P227A mean?
Barometric pressure sensor C circuit fault. The control unit has found an electrical problem in the circuit of barometric pressure sensor 'C'. The sensor measures outside air pressure, which is used to adjust fuelling and boost for altitude. Which sensor is 'C' depends on the manufacturer: I have no reliable detail for any particular make.
Can I keep driving with code P227A active?
With caution: limp mode possible, have it checked soon
Common causes — P227A
Corroded or loose sensor connector Broken or shorted wiring Faulty sensor Fault in the sensor's supply or ground Internal fault in the control unit, rare
How do you fix code P227A?
First check the sensor connector and wiring. You can usually drive, but the control unit uses fallback values and engine performance suffers. Don't put it off for long, especially if the engine is turbocharged.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2279 — Intake air system leak
- Next code: P227B — Barometric pressure sensor C range/performance
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3