P227B — Barometric pressure sensor C range/performance
| Meaning | Barometric pressure sensor 'C' gives a value that does not agree with other data, for example manifold pressure with the engine off, or altitude. The electrical circuit is not necessarily faulty: it is the value that is not believable. Which sensor is 'C' depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or sluggish response
Possible reduced-power mode
Higher fuel consumption in some cases
Irregular running at different altitudes
Common causes
Blocked air port or sensor line
Connector or wiring with abnormal resistance
Faulty manifold pressure sensor, used as a comparison
Badly clogged air filter
What to do
How to read code P227B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P227B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (7B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P227B mean?
Barometric pressure sensor C range/performance. Barometric pressure sensor 'C' gives a value that does not agree with other data, for example manifold pressure with the engine off, or altitude. The electrical circuit is not necessarily faulty: it is the value that is not believable. Which sensor is 'C' depends on the manufacturer.
Can I keep driving with code P227B active?
With caution: limp mode possible, have it checked soon
Common causes — P227B
Faulty or out-of-calibration sensor Blocked air port or sensor line Connector or wiring with abnormal resistance Faulty manifold pressure sensor, used as a comparison Badly clogged air filter
How do you fix code P227B?
Check the sensor line, the connector and the sensor itself. It can help to compare its readings with the manifold sensor with the key on and the engine off. Avoid heavy loads until it is sorted out, because fuelling and boost control are working from a doubtful value.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P227A — Barometric pressure sensor C circuit fault
- Next code: P227C — Barometric pressure sensor C circuit low
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3