P227E — Barometric pressure sensor C: erratic signal
| Meaning | The engine computer found that the signal from barometric pressure sensor C jumps or varies irregularly, without altitude or weather explaining it. It is usually a come-and-go problem, typical of a poor electrical contact. Which sensor is labelled "C" depends on the make. |
| Family | Powertrain (P) |
Typical symptoms
Occasional uneven idle
Sudden, brief loss of power
Starting that is sometimes longer
No obvious symptoms between episodes
Common causes
Wiring with a partly broken or chafed wire
Barometric sensor starting to fail
Ground or supply connections with poor contact
Vibration moving a faulty contact
What to do
How to read code P227E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P227E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (7E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P227E mean?
Barometric pressure sensor C: erratic signal. The engine computer found that the signal from barometric pressure sensor C jumps or varies irregularly, without altitude or weather explaining it. It is usually a come-and-go problem, typical of a poor electrical contact. Which sensor is labelled "C" depends on the make.
Can I keep driving with code P227E active?
With caution: limp mode possible, have it checked soon
Common causes — P227E
Loose or corroded sensor connector Wiring with a partly broken or chafed wire Barometric sensor starting to fail Ground or supply connections with poor contact Vibration moving a faulty contact
How do you fix code P227E?
Carefully wiggle the wiring and connector with the engine running to see whether the signal changes, and check the condition of the contacts. It isn't an emergency, but an intermittent fault tends to get worse, so have it looked at.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P227D — Barometric pressure sensor C: signal too high
- Next code: P227F — Air restriction or leak between air filter and MAF...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3