P227D — Barometric pressure sensor C: signal too high
| Meaning | The engine computer read a voltage from barometric pressure sensor C that is higher than atmospheric pressure could ever produce. The computer uses this reading to adjust air and fuel for altitude. Which sensor is labelled "C" depends on the make and engine. When the signal isn't believable, the computer falls back on default values. |
| Family | Powertrain (P) |
Typical symptoms
Engine feels weaker, especially uphill or at altitude
Dark smoke or a rich-mixture smell in some cases
Slightly uneven idle
Fuel use that seems higher than usual
Common causes
Signal wire shorted to the power supply
Faulty barometric pressure sensor
Broken or poorly connected ground wire
Internal fault in the engine computer (rare)
What to do
How to read code P227D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P227D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (7D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P227D mean?
Barometric pressure sensor C: signal too high. The engine computer read a voltage from barometric pressure sensor C that is higher than atmospheric pressure could ever produce. The computer uses this reading to adjust air and fuel for altitude. Which sensor is labelled "C" depends on the make and engine. When the signal isn't believable, the computer falls back on default values.
Can I keep driving with code P227D active?
With caution: limp mode possible, have it checked soon
Common causes — P227D
Corroded or loose sensor connector Signal wire shorted to the power supply Faulty barometric pressure sensor Broken or poorly connected ground wire Internal fault in the engine computer (rare)
How do you fix code P227D?
First check the sensor connector and wiring for moisture, corrosion and damaged wires. You can drive a short distance, but have it checked soon, because the computer is working with wrong data.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P227C — Barometric pressure sensor C circuit low
- Next code: P227E — Barometric pressure sensor C: erratic signal
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3