P22A0 — NOx sensor circuit low, bank 1 sensor 2
| Meaning | The control unit measured a signal that is too low in the NOx sensor circuit. This usually means a wire shorted to ground, a short circuit, or a missing supply in the circuit. The exact meaning of 'sensor 2' depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Emission system fault warning
Possible power limitation
AdBlue-related message
Failed emissions test
Common causes
Wet or corroded connector
Faulty NOx sensor
Missing or weak sensor supply
Faulty sensor control module
What to do
How to read code P22A0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22A0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (A0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22A0 mean?
NOx sensor circuit low, bank 1 sensor 2. The control unit measured a signal that is too low in the NOx sensor circuit. This usually means a wire shorted to ground, a short circuit, or a missing supply in the circuit. The exact meaning of 'sensor 2' depends on the manufacturer.
Can I keep driving with code P22A0 active?
With caution: limp mode possible, have it checked soon
Common causes — P22A0
Sensor wiring touching ground Wet or corroded connector Faulty NOx sensor Missing or weak sensor supply Faulty sensor control module
How do you fix code P22A0?
Check the sensor wiring and connector, looking for places where a wire may touch the chassis. Have it checked soon, since the system may reduce performance if the fault persists.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P229F — Downstream NOx sensor: implausible signal
- Next code: P22A1 — NOx sensor circuit high, bank 1 sensor 2
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3