Skip to content
Fault code dictionary (DTC)

P22A1 — NOx sensor circuit high, bank 1 sensor 2

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a signal that is too high in the NOx sensor circuit. This usually points to a broken wire, an open contact, or a wire touching a power supply. The exact meaning of 'sensor 2' depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Emission system fault warning
Possible power limitation
AdBlue-related message
Failed emissions test

Common causes

Broken wire or open contact in the connector
Corroded connector terminals
Faulty NOx sensor
Wire touching a power supply
Faulty sensor control module

What to do

Check that the connector is well seated and free of corrosion, and that the wires are not broken. Have it checked soon, since the system may limit performance if the fault remains.

How to read code P22A1

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P22A1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (A1) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P22A1 mean?

NOx sensor circuit high, bank 1 sensor 2. The control unit measured a signal that is too high in the NOx sensor circuit. This usually points to a broken wire, an open contact, or a wire touching a power supply. The exact meaning of 'sensor 2' depends on the manufacturer.

Can I keep driving with code P22A1 active?

With caution: limp mode possible, have it checked soon

Common causes — P22A1

Broken wire or open contact in the connector Corroded connector terminals Faulty NOx sensor Wire touching a power supply Faulty sensor control module

How do you fix code P22A1?

Check that the connector is well seated and free of corrosion, and that the wires are not broken. Have it checked soon, since the system may limit performance if the fault remains.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes