P22BA — Bank 2 Sensor 2 O2 sensor positive current circuit high
| Meaning | The engine computer detected too high a voltage on the positive control current circuit of the wide-band oxygen sensor fitted after the catalytic converter on bank 2. The sensor can no longer work properly, so the computer cannot trust its reading. This sensor mostly monitors the catalytic converter, so the car usually drives normally. |
| Family | Powertrain (P) |
Typical symptoms
Usually no noticeable change in driving
Other codes for the bank 2 downstream sensor
Possible failure at an emissions inspection
Common causes
Corroded connector or bent terminals
Failed sensor internally
Wiring damaged by exhaust heat
Faulty engine computer, uncommon
What to do
How to read code P22BA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22BA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (BA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22BA mean?
Bank 2 Sensor 2 O2 sensor positive current circuit high. The engine computer detected too high a voltage on the positive control current circuit of the wide-band oxygen sensor fitted after the catalytic converter on bank 2. The sensor can no longer work properly, so the computer cannot trust its reading. This sensor mostly monitors the catalytic converter, so the car usually drives normally.
Can I keep driving with code P22BA active?
With caution: limp mode possible, have it checked soon
Common causes — P22BA
Sensor wire touching a power supply Corroded connector or bent terminals Failed sensor internally Wiring damaged by exhaust heat Faulty engine computer, uncommon
How do you fix code P22BA?
First check the connector and wiring of the bank 2 sensor behind the catalytic converter, looking for loose, burnt or pinched wires. It is not an emergency, but don't leave it for long because the computer loses its check on the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22B9 — Bank 2 downstream O2 sensor positive current contr...
- Next code: P22BB — Bank 2 Sensor 2 O2 sensor reference voltage circui...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3