P22BB — Bank 2 Sensor 2 O2 sensor reference voltage circuit/open
| Meaning | The engine computer cannot detect the reference voltage of the wide-band oxygen sensor after the catalytic converter on bank 2. The circuit looks broken or is not responding. Without this reference the sensor cannot give a reliable reading. |
| Family | Powertrain (P) |
Typical symptoms
Usually normal driving
Downstream sensor not monitored by the computer
Possible failure at an emissions inspection
Common causes
Broken wire in the harness
Failed sensor
Wiring damaged near the exhaust
Faulty engine computer, uncommon
What to do
How to read code P22BB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22BB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (BB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22BB mean?
Bank 2 Sensor 2 O2 sensor reference voltage circuit/open. The engine computer cannot detect the reference voltage of the wide-band oxygen sensor after the catalytic converter on bank 2. The circuit looks broken or is not responding. Without this reference the sensor cannot give a reliable reading.
Can I keep driving with code P22BB active?
With caution: limp mode possible, have it checked soon
Common causes — P22BB
Unplugged or corroded connector Broken wire in the harness Failed sensor Wiring damaged near the exhaust Faulty engine computer, uncommon
How do you fix code P22BB?
Check that the connector of the bank 2 sensor behind the catalytic converter is fully seated and clean, then inspect the wires along the exhaust. You can drive for short periods, but have the circuit checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22BA — Bank 2 Sensor 2 O2 sensor positive current circuit...
- Next code: P22BC — Bank 2 Sensor 2 O2 sensor reference voltage perfor...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3