P22DB — Cylinder 1 alternative fuel injector control circuit high
| Meaning | The engine computer detected a higher-than-expected voltage in the control circuit of the cylinder 1 alternative fuel injector. It can come from contact with a power supply or from a fault in the electronics that drive the injector. The injector may not work as commanded. |
| Family | Powertrain (P) |
Typical symptoms
Rough running
Reduced power
Switch to the main fuel
Jerking when accelerating
Higher fuel consumption
Common causes
Injector faulty internally
Damaged connector
Damaged wiring
Faulty computer driver (rare)
What to do
How to read code P22DB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22DB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (DB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22DB mean?
Cylinder 1 alternative fuel injector control circuit high. The engine computer detected a higher-than-expected voltage in the control circuit of the cylinder 1 alternative fuel injector. It can come from contact with a power supply or from a fault in the electronics that drive the injector. The injector may not work as commanded.
Can I keep driving with code P22DB active?
With caution: limp mode possible, have it checked soon
Common causes — P22DB
Control wire touching a power supply Injector faulty internally Damaged connector Damaged wiring Faulty computer driver (rare)
How do you fix code P22DB?
Have the cylinder 1 injector wiring and connector checked and make sure there are no stray contacts. If you smell gas, stop the car and have the system inspected.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22DA — Cylinder 1 alternative fuel injector control circu...
- Next code: P22DC — Cylinder 1 alternative fuel injector control circu...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3