P22E3 — Cylinder 3 alternative fuel injector: control signal too high
| Meaning | The control unit measured a higher voltage than expected on the control circuit of the cylinder 3 alternative fuel injector (for example the gas injector on a bi-fuel system). Usually the wire is touching a live supply or another powered wire, or the driver stage inside the control unit is not working properly. The cylinder may not receive the alternative fuel as it should. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or power dropouts
The car stays on or switches back to the normal fuel
Hard starting on the alternative fuel
Abnormal running or consumption on the alternative fuel system
Common causes
Damaged connector with bent terminals touching each other
Poorly done earlier wiring repair
Injector with a faulty winding
Faulty driver stage in the control unit (rare)
What to do
How to read code P22E3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22E3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (E3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22E3 mean?
Cylinder 3 alternative fuel injector: control signal too high. The control unit measured a higher voltage than expected on the control circuit of the cylinder 3 alternative fuel injector (for example the gas injector on a bi-fuel system). Usually the wire is touching a live supply or another powered wire, or the driver stage inside the control unit is not working properly. The cylinder may not receive the alternative fuel as it should.
Can I keep driving with code P22E3 active?
With caution: limp mode possible, have it checked soon
Common causes — P22E3
Control wire touching a powered wire Damaged connector with bent terminals touching each other Poorly done earlier wiring repair Injector with a faulty winding Faulty driver stage in the control unit (rare)
How do you fix code P22E3?
First check the wiring and connector of the cylinder 3 injector, looking for wires touching each other or makeshift joints. Then the voltage on the control wire and the injector resistance should be measured. You can use the normal fuel in the meantime, but the check should not be put off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22E2 — Cylinder 3 alternative fuel injector: control sign...
- Next code: P22E4 — Cylinder 3 alternative fuel injector: performance...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3