P22E5 — Cylinder 4 alternative fuel injector: open circuit
| Meaning | The control unit detected that the control circuit of the cylinder 4 alternative fuel injector (for example the gas injector on a bi-fuel system) is open. In practice it does not see the electrical load of the injector, as if the wire or the injector were disconnected. The cylinder may not receive the alternative fuel as intended. |
| Family | Powertrain (P) |
Typical symptoms
Rough or jerky running on the alternative fuel
Loss of power
The car stays on or switches back to the normal fuel
Hard starting on the alternative fuel
Common causes
Broken or damaged wire
Injector with an open internal winding
Injector supply fuse or relay
Faulty control unit (rare)
What to do
How to read code P22E5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22E5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (E5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22E5 mean?
Cylinder 4 alternative fuel injector: open circuit. The control unit detected that the control circuit of the cylinder 4 alternative fuel injector (for example the gas injector on a bi-fuel system) is open. In practice it does not see the electrical load of the injector, as if the wire or the injector were disconnected. The cylinder may not receive the alternative fuel as intended.
Can I keep driving with code P22E5 active?
With caution: limp mode possible, have it checked soon
Common causes — P22E5
Corroded or loosely seated injector connector Broken or damaged wire Injector with an open internal winding Injector supply fuse or relay Faulty control unit (rare)
How do you fix code P22E5?
First check the connector of the cylinder 4 injector and the wiring to the control unit, looking for severed wires or corroded terminals. Then the injector resistance should be measured. You can use the normal fuel, but have it checked soon to avoid straining the engine and catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22E4 — Cylinder 3 alternative fuel injector: performance...
- Next code: P22E6 — Cylinder 4 alternative fuel injector: control sign...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3