P22F6 — Cylinder 8 alternative fuel injector control circuit low
| Meaning | The control unit detected that the control circuit of the cylinder 8 alternative fuel injector (for example a gas injector) has a voltage lower than expected. In practice, the electrical signal that drives the injector is missing or being pulled to ground. Cylinder 8 may therefore receive less alternative fuel than it should. |
| Family | Powertrain (P) |
Typical symptoms
Rough running, especially on gas
Loss of power when accelerating
Forced switch to petrol or the main fuel
Fuel consumption that seems higher than usual
Common causes
Injector connector corroded or not fully seated
Alternative fuel injector with an internal coil short
Control unit or gas module with a damaged driver stage
Moisture or heat damage to the wiring near the engine
What to do
How to read code P22F6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22F6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (F6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22F6 mean?
Cylinder 8 alternative fuel injector control circuit low. The control unit detected that the control circuit of the cylinder 8 alternative fuel injector (for example a gas injector) has a voltage lower than expected. In practice, the electrical signal that drives the injector is missing or being pulled to ground. Cylinder 8 may therefore receive less alternative fuel than it should.
Can I keep driving with code P22F6 active?
With caution: limp mode possible, have it checked soon
Common causes — P22F6
Cylinder 8 injector wiring with damaged insulation or shorted to ground Injector connector corroded or not fully seated Alternative fuel injector with an internal coil short Control unit or gas module with a damaged driver stage Moisture or heat damage to the wiring near the engine
How do you fix code P22F6?
First check the connector and wiring of the cylinder 8 injector for chafing, burn marks or water. You can drive carefully, but have the circuit checked soon, because a cylinder that runs badly also stresses the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22F5 — Cylinder 8 alternative fuel injector: open circuit
- Next code: P22F7 — Cylinder 8 alternative fuel injector control circu...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3