P22F7 — Cylinder 8 alternative fuel injector control circuit high
| Meaning | The control unit detected too high a voltage in the control circuit of the cylinder 8 alternative fuel injector. This usually means the wire is touching a supply voltage, or the circuit is open and the signal is stuck high. The injector may not work as commanded. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or misfires on cylinder 8
Hard starting on gas
Loss of power
Automatic switch to the main fuel
Common causes
Injector connector with bent or corroded terminals
Injector with a broken winding
Fault in the gas control module or control unit
Wiring poorly repaired in the past
What to do
How to read code P22F7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22F7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (F7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22F7 mean?
Cylinder 8 alternative fuel injector control circuit high. The control unit detected too high a voltage in the control circuit of the cylinder 8 alternative fuel injector. This usually means the wire is touching a supply voltage, or the circuit is open and the signal is stuck high. The injector may not work as commanded.
Can I keep driving with code P22F7 active?
With caution: limp mode possible, have it checked soon
Common causes — P22F7
Injector control wire broken or touching a power supply Injector connector with bent or corroded terminals Injector with a broken winding Fault in the gas control module or control unit Wiring poorly repaired in the past
How do you fix code P22F7?
Have the wiring and connector of the cylinder 8 injector checked, measuring continuity and voltage on the circuit. Don't ignore it for long: if the car jerks or uses fuel oddly, avoid pushing it and have the system inspected.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22F6 — Cylinder 8 alternative fuel injector control circu...
- Next code: P22F8 — Cylinder 8 alternative fuel injector range/perform...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3