P22FC — NOx sensor slow response low to high, bank 1 sensor 2
| Meaning | The control unit detected that the NOx sensor downstream of the SCR system (sensor 2, bank 1) responds too slowly when nitrogen oxides rise. This sensor is used to check how well the SCR catalyst has cleaned the exhaust. With a slow reading, the efficiency check is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard warnings for AdBlue or emissions
Abnormal AdBlue consumption
Possible power limitation
Inspection problems
Common causes
Dirty or degraded sensing element
Exhaust leak near the sensor
Faulty wiring or connector
Reduced SCR catalyst efficiency affecting the readings
Sensor module fault
What to do
How to read code P22FC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22FC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (FC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22FC mean?
NOx sensor slow response low to high, bank 1 sensor 2. The control unit detected that the NOx sensor downstream of the SCR system (sensor 2, bank 1) responds too slowly when nitrogen oxides rise. This sensor is used to check how well the SCR catalyst has cleaned the exhaust. With a slow reading, the efficiency check is not reliable.
Can I keep driving with code P22FC active?
With caution: limp mode possible, have it checked soon
Common causes — P22FC
Aged downstream NOx sensor Dirty or degraded sensing element Exhaust leak near the sensor Faulty wiring or connector Reduced SCR catalyst efficiency affecting the readings Sensor module fault
How do you fix code P22FC?
Have the data of both NOx sensors read and compared, then check the wiring and exhaust sealing. You can drive carefully, but the fault should be checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22FB — NOx sensor sensing element, bank 1 sensor 1
- Next code: P22FD — NOx sensor slow response high to low, bank 1 senso...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3